Laser On Time; Time Delay To Low Power Mode - Symbol Cyclone M2000 Series Product Reference Manual

Laser On Time

This parameter sets the maximum time decode processing continues during a scan
attempt. It is programmable in 0.1 second increments from 0.5 to 9.9 seconds.
To set a Laser On Time, scan the bar code below. Next scan two numeric bar codes
beginning on page 3-130
second must have a leading zero. For example, to set an on time of 0.5 seconds, scan
the bar code below, then scan the "0" and "5" bar codes. If you make an error, or wish
to change your selection, scan the

Time Delay to Low Power Mode

This parameter sets the time the scanner remains active after any scanning activity. Scan
one of the four options. Depending on the selection, the scanner enters a low power mode
15, 30, 60 or 90 minutes after the last attempted decode. To awaken the scanner, present
the bar code you wish to scan to the scan window.
15 Minutes
60 Minutes
that correspond to the desired on time. Times less than 1.0
Cancel bar code on
Laser On Time
Parameter Menus
page 3-132.
30 Minutes
90 Minutes
3-23