ZyXEL Communications ZyWall P1 User Manual page 211

ZyWALL P1 User's Guide
Figure 107 SNMP
The following table describes the labels in this screen.
Table 75 SNMP
LABEL
SNMP
Configuration
Get Community
Set Community
Trap
Community
Destination
SNMP
Service Port
Service Access
Secure Client IP
Address
Apply
Reset
210
DESCRIPTION
Enter the Get Community, which is the password for the incoming Get and GetNext
requests from the management station. The default is public and allows all requests.
Enter the Set community, which is the password for incoming Set requests from the
management station. The default is public and allows all requests.
Type the trap community, which is the password sent with each trap to the SNMP
manager. The default is public and allows all requests.
Type the IP address of the station to send your SNMP traps to.
You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Select the interface(s) through which a computer may access the ZyWALL using this
service.
A secure client is a "trusted" computer that is allowed to communicate with the
ZyWALL using this service.
Select All to allow any computer to access the ZyWALL using this service.
Choose Selected to just allow the computer with the IP address that you specify to
access the ZyWALL using this service.
Click Apply to save your customized settings.
Click Reset to begin configuring this screen afresh.
Chapter 13 Remote Management