Toshiba T2150 series Maintenance Manual page 157

4.17 T2150CDT FL
Removing the T2150CDT FL
CAUTION: When you remove the FL, be careful not to let any dust or other foreign
matter contaminate the LCD panel. Any contamination can affect performance of the
FL.
To remove the T2150CDT's FL, follow the steps below and refer to figure 4-31.
1. Turn off the power to the T2150CDT. Disconnect the AC power cord and all
external cables connected to the connector.
2. Remove the battery pack, optional memory module, optional PCMCIA card,
display mask, FL inverter board, and LCD module as described in sections 4.2
through 4.4, 4.11, 4.15, and 4.16.
3. Place the LCD module face down and remove three small screws (figure
4-31).
4. Lift the FL tube out of the frame (figure 4-31).
Installing the T2150CDT FL
To install the T2150CDT's FL unit, follow the steps below.
1. Replace the FL tube in the frame and seat the FL tube cover, then secure it with
three small screws (figure 4-31.)
2. Install the LCD module, FL inverter board, display mask, optional PCMCIA card,
optional memory module, and battery pack as described in sections 4.16, 4.15,
4.11, and 4.4 back through 4.2.
4-42
Figure 4-31 Removing the FL unit
T2150 Series