Toshiba T2150 series Maintenance Manual page 129

4. Carefully lift the keyboard to expose the keyboard connector (figure 4-11).
5. Disconnect the keyboard cable from the pressure-plate connector (PJ14) on the
system board (figure 4-11).
Installing the Keyboard
To install the T2150 series keyboard, follow the steps below and refer to figures 4-10 and
4-11.
1. Connect the keyboard cable to the pressure plate connector (PJ14) on the
system board (figure 4-11).
2. Replace the keyboard. Fit notches on the back of the keyboard into corre-
sponding holes on the computer and lay the keyboard in place (figure 4-11).
3. Insert the keyboard brace between the AccuPoint cable and the underside of
the keyboard (figure 4-10).
4. Secure the five latches on the keyboard base (figure 4-10).
5. Install the optional PCMCIA card, optional memory module, and battery pack
as described in sections 4.2 through 4.4.
4-14
Figure 4-11 Removing the keyboard
T2150 Series