Toshiba T2150 series Maintenance Manual page 132

Installing the Hard Disk Drive and Sound Board
To install the T2150 series hard disk drive, follow the steps below and refer to figures
4-12 through 4-14.
1. Place the HDD in the HDD slot and slide the HDD to the right. Make sure the
HDD connects to the HDD connector on the system board (PJ502) (figure 4-14).
2. Secure the HDD bracket with the two M2.5x8 silver screws (figure 4-14).
3. Seat the palm rest cover-support, and secure the left side cover (figure 4-14).
4. Seat the sound board and connect the sound cable to PJ1 on the sound board.
5. Seat the sound board cover and side cover and secure three M2.5x4 screws.
6. Turn the computer over and secure the HDD with the four pan-head M3x6
screws (figure 4-12).
7. Install the keyboard, optional memory module, optional PCMCIA card, and
battery pack as described in sections 4.5 back through 4.2.
T2150 Series
4-17