Toshiba T2150 series Maintenance Manual page 152

Installing the T2150CDS FL
To install the T2150CDS's FL unit, follow the steps below and refer to figures 4-25 to 4-28.
1. Seat the FL, gently press it securely in place, and cover it with the end of the
reflector sheet. Be careful not to pull or apply tension to the reflector sheet.
2. Connect the FL.
3. Gently pull back the P chassis and place the B/L holder between the reflector
sheet and the P chassis.
4. Rotate the B/L holder and P chassis into place and gently press the P chassis to
secure the latch.
5. Connect the signal cable. Press the connector with the flat of your finger to
secure the connection. To avoid damaging the connector, do not push it with your
fingernail or the end of your fingertip.
6. Rotate the SEG board back into place.
7. Replace the two ground plates.
8. Secure the SEG board with four screws.
9. Set the LCD module in its frame and secure it with four screws.
10. Turn the module over and secure the 11 latches of the frame.
T2150 Series
4-37