Center/Border Erase - Lanier 5484 Operator's Manual

Center/Border Erase

This function erases the center and/or all four sides of the original image. This
is useful for avoiding shadows on the copy image caused by the binding or
splayed pages of books etc.
Two modes of this feature are available:
Center
This mode erases the Center margin of the original image.
Border
This mode erases the edges area of the original image.
Limitation
This function will not take effect if the size of the original cannot be detected.
Note
You can change the width of the erased margin as follows:
Metric version
Inch version
The default width of the erased margin is as follows. You can change this set-
tings with the User Tools. See "Border Erase Width"
and "Centre Erase Width"
Metric version
Inch version
The width of the erased margin varies depending on the reproduction ratio.
If the size of the original is different from sizes listed in the following chart,
the erased margin might be shifted.
3 – 50 mm (in 1 mm steps)
0.1" – 2.0" (in 0.1" steps)
P.318 "Adjust Image".
10 mm
0.4"
Center/Border Erase
P.318 "Adjust Image"
2
135