Fuji Xerox ApeosPort-V C5575 User Manual page 52

2 Product Overview
No. Component
5 Adjusting foot
6 RESET button
7 Rear right cover
8 Parallel interface connector
(optional)
9 USB 2.0 interface connector
10 10BASE-T/100BASE-TX
connector
Note
2
Inside
7
No. Component
1 Drum cartridge release lever
2 Toner cartridges
3 Main power switch
4 Waste toner container (R5)
5 Drum cartridges
(R1, R2, R3, R4)
6 Drum cartridge cover
52
Prevents the machine from toppling over. Move the machine to its
installation site and then rotate this adjuster in clockwise direction until it
touches a floor.
Automatically switches the machine off when a current leakage is detected.
Make sure that this cover is attached. Open this cover when connecting an
interface cable.
Connects to a Centronics-conformed interface cable, and connects the
machine to a computer.
Connects a USB memory cable for printing.
Connects to a network cable. To use this as a Gigabit Ethernet interface
connector, install the Gigabit Ethernet Kit (optional).
• The Memory Card Reader and a USB memory device cannot be connected to the machine at the
same time. The machine will recognize the one that is connected first.
Unlock this lever when replacing a drum cartridge.
Contains Black (K), Cyan (C), Magenta (M), and Yellow (Y) toner (image
forming powder).
Switches the main power on/off of the machine. Always follow the
instructions by the system administrator.
Important • Always switch the power off before switching the main power off. Refer
to "Power Source" (P.61).
Collects waste toner.
Contains photoconductors R1, R2, R3, and R4.
Open this cover when replacing a drum cartridge or cleaning the interior of
the machine.
Function
1
2
3
4
5
6
Function