Stack Select - Kyocera Mita S-9100DN Operation Manual

1
Press the MENU key.
2
Press the 3 or 4 key repeatedly until Paper
Handling > appears.
Paper Handling >
3 Press the 2 key.
4 Press the 3 or 4 key repeatedly until >Duplex Mode
appears.
>Duplex Mode
None
5
Press the ENTER key. A blinking question mark (?) ap-
pears.
>Duplex Mode
?None
6
Press the 3 or 4 key to display the desired duplex
mode. The display changes as shown below.
None (default)
Short edge bind
Long edge bind
7
When the desired duplex mode is displayed, press the
ENTER key.
8
Press the MENU key. The message display returns to
Ready.
Selecting the Output Device
You can select whether printouts will be received by the print-
er's face-down output tray or to the optional document finisher's
output tray.
1
Press the MENU key.
2
Press the 3 or 4 key repeatedly until Paper
Handling > appears.
Paper Handling >
3 Press the 2 key.
Chapter 3 Using the Operator Panel
4
Press the 3 or 4 key repeatedly until >Stack
Select appears.
>Stack Select
Finisher F-down
5
Press the ENTER key. A blinking question mark (?) ap-
pears. The selected output device will be displayed.
>Stack Select
?Finisher F-down
6
Press the 3 or 4 key to display the desired destination.
The output tray changes as shown below.
Face-down tray
Finisher F-up
Finisher F-down
7
When the desired paper source displayed, press the
ENTER key.
8
Press the MENU key. The message display returns to
Ready.
Adjusting the Stitch Positions
When installing the option document finisher DF-75, adjust the
stitch positions using the following procedures. In the default
settings, the stitch position is set in the center of the paper. De-
pending on the paper, a certain amount of deviation will occur.
In this case, also use this menu to adjust the stitch position.
The adjustment can be done by moving the stitch position ad-
justment gear in the document finisher.
For example, select the range from -57 to +57 (1 = approxi-
mately 0.14 mm) to move the stitch position approximately 8
mm as shown in the following figure. The default setting is 000
(center of the paper.)
Default stitch position
(center of the paper)
Feed direction
(Approx. 8 mm)
-57 +57
(Approx. 8 mm)
3-44