Kyocera Mita S-9100DN Operation Manual page 65

Chapter 3 Using the Operator Panel
6
Press the 3 or 4 key to increase or decrease the value
of the figure where the cursor is blinking and set the
desired time. The timer can be set between 5 and 240
min, in 5-minute increments. You can use the 2 and 1
keys to move the cursor right and left.
7
Press the ENTER key.
8
Press the MENU key. The message display returns to
Ready.
Q Q Q Q Turning Off the Sleep Timer
You can turn off the sleep timer function by following the proce-
dure given below.
1
Press the MENU key.
2 Press the 3 or 4 key repeatedly until Others > ap-
pears.
Others
3
Press the 2 key.
4
Press the 3 or 4 key repeatedly until >Sleep Timer
>appears.
>Sleep timer
030 min.
5
Press the 2 key and display >>Sleep Mode.
>>Sleep Mode
On
6
Press the ENTER key. A blinking question mark (?) ap-
pears.
>>Sleep Mode
? On
7
Select Off using the 3 or 4 key.
>>Sleep Mode
? Off
8
Press the ENTER key.
9
Press the MENU key. The message display returns to
Ready.
3-49
>
>
Received Data Dumping
It is possible to print data received by the printer as hexadeci-
mal code for the purposes of debugging programs and files.
1
Press the MENU key.
2
Press the 3 or 4 key repeatedly until Others > ap-
pears.
Others
3 Press the 2 key.
4 Press the 3 or 4 key repeatedly until >Print HEX-
DUMP appears.
>Print HEX-DUMP
5
Press the ENTER key. A question mark (?) appears.
>Print HEX-DUMP?
6
Press the ENTER key again. Processing appears for
a second, and then Waiting appears.
Processing
Waiting
7
Send data to be dumped to the printer. The message
Processing will be displayed while receiving the da-
ta.
Once the dumped data you require has been printed, it
is possible to cancel the printing of any further dumped
data by taking the printer offline by pressing the GO
key and then pressing the CANCEL key.
8
Once all data has been received, the message Wait-
ing will appear. Press the GO key to finish printing.
Printer Resetting
The procedure described below resets the printer's temporary
conditions, such as the current unit of measurement, page ori-
entation, font, character code set, margins, etc., set by com-
mands to their default values.
>