Kyocera Mita S-9100DN Operation Manual page 58

4
Press the 3 or 4 key repeatedly until >Cassette
Size appears. The paper size is also displayed.
>Cassette1 size
A4
NOTE
• Casette3 Size > or Cassette4 Size > appears
when an option paper feeder (PF-70) is installed.
• Casette3 Size > appears when an option paper
feeder (PF-75) is installed.
If option paper feeders are added, Cassette1 Size
and Cassette2 Size will appear for the standard pa-
per cassette and Cassette3 Size, and Cassette4
Size will appear for the option paper feeders.
5
Press the MENU key. The message display returns to
Ready.
Paper Size Unit Selection
The paper size unit (metric or inch system) used in the LCD can
be selected beforehand. At the time of Ready or when selecting
the size display, the unit for some paper may be replaced with
the counterpart as shown in the following table.
metric
A3 Ledger (LD)
B4 Legal (LG)
A4 Letter (LT)
A4-R (A4) Letter-R (LT)
B5 Letter-R (LT)
B5-R (B5) Statement (ST)
A5 Statement (ST)
Folio Legal (LG)
( ) abbreviated display
For example, when placing the letter size paper in the cassette
while "mm" unit is selected. "A4" will be displayed in the LCD. To
correct the display, use the following procedures.
NOTE
You can set the option paper feeder PF-70 using the same pro-
cedures, but when using the paper feeder PF-75, you cannot se-
lect the paper size and unit.
1
Press the MENU key.
2
Press the 3 or 4 key repeatedly until Paper
Handling appears.
Paper Handling >
3
Press the 2 key.
Inch
Chapter 3 Using the Operator Panel
4
Press the 3 or 4 key repeatedly until >Cassette1
size appears.
>Cassette1 size
5
Press the 2 key. >>Unit appears.
>>Unit
mm
6
Press the ENTER key. A blinking question mark (?) ap-
pears.
>>Unit
? mm
7
Press the 3 or 4 key to select mm or inch.
8
Select mm or inch, and then, press the ENTER key.
9
Press the MENU key. The message display returns to
Ready.
Setting the Cassette Paper Type
Make this setting to match the paper type fed from the paper
cassette of the printer. If the paper type is set correctly, you can
perform printing using the media type selection function from the
application (printer driver). The factory default setting is Plain.
For more details about the paper types that can be fed from the
paper cassette, see Paper Type on page
1
Press the MENU key.
2
Press the 3 or 4 key repeatedly until Paper
Handling > appears.
Paper Handling >
3
Press the 2 key.
4 Press the 3 or 4 key repeatedly until >Cassette 1
Type appears. The paper type also displayed.
>Cassette 1 Type
Plain
5-5.
3-42