Loading Paper Into The Mp (Multi-Purpose) Tray - Kyocera Mita S-9100DN Operation Manual

Chapter 2 How to Load Paper
IMPORTANT
• There is a sticker ( in the illustration) indicating paper capac-
ity attached to the inside of the paper cassette. Do not load
paper above this limit.
• When loading paper into the paper cassette, make sure that
the print side is facing upward. (The print side is the side fac-
ing upward when the package is opened.)
• Check that the paper guide makes secure contact with the pa-
per. If there is a gap, adjust the position of the paper guide.
• If small-size paper jams occur frequently under high tempera-
ture and high humidity conditions, reduce the number of
sheets to the level line indicated on the sticker
5
Set the supplied paper size plate so that the size of the
paper loaded can be checked by looking at the front of
the paper cassette.
6
Gently push the paper cassette back in.
NOTE
Before leaving the printer in disuse for a prolonged period of
time, remove the paper from the paper cassette(s) and seal it in
its original packaging to protect from moisture. Also, when stor-
ing paper in a high temperature and high humidity environment,
seal it in a moisture-proof bag.
2-2
1.2 Loading Paper into the MP (Multi-Pur-
Special paper as well as standard paper can be loaded into the
MP tray. When printing onto transparencies or thick paper, be
sure to use the MP tray.
NOTE
• The number of sheets of standard paper that can be loaded in
the MP tray at a time is approximately 200.
• When using transparencies, load a single sheet at a time.
.
IMPORTANT
When setting special paper, such as transparencies and thick
paper, into the M tray, select the type of paper by referring to
3.Paper Type on page
UPPER LEVEL
1
2
pose) Tray
5-5.
Open the MP tray.
Adjust the insert guides to the size of the paper to be
loaded.