Kyocera Mita S-9100DN Operation Manual page 39

Chapter 3 Using the Operator Panel
8
Press the 3 or 4 key repeatedly until the desired alter-
native emulation appears.
9
Press the ENTER key.
10
Press the MENU key. The message display returns to
Ready.
Auto Printing of KPDL Error
The printer can be set to print error data during KPDL emulation.
If this is set to On, error data will be printed only when trouble oc-
curs during printing. The factory default setting is Off.
1
Press the MENU key.
2
Press the 3 or 4 key repeatedly until Emulation >
appears.
Emulation
PCL 6
3
Press the ENTER key. A blinking question mark (?) ap-
pears.
Emulation
?PCL 6
4
Select KPDL or KPDL (AUTO) using the 3 or 4 key.
Emulation
?KPDL
5
Press the ENTER key.
6
Press the 2 key. The message display changes to that
shown below. If >Print
when the KPDL (AUTO) emulation is selected, press
the 3 or 4 key to change it.
>Print KPDL Errs
Off
7
Press the ENTER key. A blinking question mark (?) ap-
pears.
>Print KPDL Errs
?Off
8
Select On using the 3 or 4 key.
>Print KPDL Errs
?On
3-23
>
Errs is displayed
KPDL
9
Press the ENTER key.
10
Press the MENU key. The message display returns to
Ready.
KC-GL Pen Width
The KC-GL emulation mode enables you to set the pen widths
in dots, for pen numbers 1 to 8, and the KC-GL page size.
1
Press the MENU key.
2 Press the 3 or 4 key repeatedly until Emulation ap-
pears on the message display.
Emulation
PCL 6
3
If the current emulation is other than KC-GL, press the
ENTER key. A blinking question mark (?) appears.
Emulation
?PCL 6
4 Press the 3 or 4 key repeatedly until KC-GL appears.
Emulation
?KC-GL
5
Press the ENTER key.
Emulation
KC-GL
6
Press the 2 key to move to the >KC-GL Pen Width
submenu.
>KC-GL
Pen Width
7
Press the 2 key.
>>Pen(1) Width
01 dot(s)
8
Press the 3 or 4 key repeatedly until the desired pen
number of 1 to 8 appears.
9
When the desired pen number is displayed, press the
ENTER key.
>
>
>