Operating An Option Hard Disk - Kyocera Mita S-9100DN Operation Manual

Chapter 3 Using the Operator Panel
5
Press the ENTER key. A blinking question mark (?) ap-
pears.
>EcoPrint Mode
? Off
6
Select On or Off using the 3 or 4 key.
7
Press the ENTER key.
8
Press the MENU key. The message display returns to
Ready.
Resolution
You can set the default print resolution in three ways: 300 dpi,
600 dpi and Fast 1200 mode. The clarity of printed characters
and graphics becomes sharper in this order. (The factory setting
is Fast 1200 mode.)
1
Press the MENU key.
2 Press the 3 or 4 key repeatedly until Print Quali-
ty > appears.
Print Quality
3 Press the 2 key.
4
Press the 3 or 4 key repeatedly until >Resolution
appears.
>Resolution
Fast 1200 mode
5
Press the ENTER key. A blinking question mark (?) ap-
pears.
>Resolution
? Fast 1200 mode
6
Select Fast 1200 mode or 300 dpi, 600 dpi using the 3
or 4 key.
7
Press the ENTER key.
8
Press the MENU key. The message display returns to
Ready.
Adjusting the Print Density
The print density can be adjusted in five steps: from 01 (light) to
05 (dark). The factory setting is 03.
3-31
>
1
Press the MENU key.
2
Press the 3 or 4 key repeatedly until Print Quali-
ty > appears.
Print Quality
3 Press the 2 key.
4 Press the 3 or 4 key repeatedly until >Print Den-
sity appears.
>Print Density
03
5
Press the ENTER key. A blinking question mark (?) ap-
pears.
>Print Density
? 03
6
Select the print density from five steps from 01 (light) to
05 (dark) using the 3 or 4 key.
7
Press the ENTER key.
8
Press the MENU key. The message display returns to
Ready.

2.2.9 Operating an Option Hard Disk

By installing the option hard disk into the printer, the e-MPS
function can be used. The printer's menu selection system al-
lows you to perform the following operations on the hard disk.
If the option hard disk is not formatted, the >Format menu
will automatically appear on the message display.
• Reading data
• Writing data
• Deleting data
• Printing of list of partitions
Reading Data
Data stored on a hard disk can be read. To read data on a hard
disk, proceed as follows.
1
Press the MENU key.
>