Sleep Timer - Kyocera Mita S-9100DN Operation Manual

2
Press the 3 or 4 key repeatedly until Others > ap-
pears.
Others
3
Press the 2 key.
4 Press the 3 or 4 key repeatedly until >MSG
Language appears. The default message language is
English.
>MSG Language
English
5
To change the language, press the ENTER key. A
blinking question mark (?) appears.
>MSG Language
? English
6
Press the 3 key. The display cycles through the avail-
able selections in the following order (The 4 key cycles
in the reverse order):
English
Francais
Deutsch
Italiano
Nederlands
7
Press the ENTER key.
8
Press the MENU key. The message display returns to
Ready.
Automatic Form Feed Timeout Setting
When the printer receives no data for a certain time, it times out
and releases the current interface: it prints whatever data it has
in its buffer and feeds out the page. You can adjust the time-out
time as follows:
1
Press the MENU key.
2
Press the 3 or 4 key repeatedly until Others > ap-
pears.
Others
>
>
Chapter 3 Using the Operator Panel
3
Press the 2 key.
4
Press the 3 or 4 key repeatedly until >Form Feed
Time Out appears. The default setting is 30 seconds.
>Form Feed
Time Out 030sec.
5
Press the ENTER key. A blinking cursor (_) appears.
>Form Feed
Time Out 030sec.
6 Press the 3 or 4 key to increase or decrease the value
of the figure where the cursor is blinking and set the
desired time. The time can be set between 0 and 495
seconds, in 5-second increments. (The printer does not
timeout with the value set to 0.) You can use the 2 and
1 keys to move the cursor right and left.
7
Display the desired time and press the ENTER key.
8
Press the MENU key. The message display returns to
Ready.
Sleep Timer Setting
The printer has a sleep timer to conserve power when the print-
er is not printing, processing, or receiving data. You can adjust
the timer value, the length of time the printer waits before enter-
ing sleeping mode in the absence of data.
1
Press the MENU key.
2 Press the 3 or 4 key repeatedly until Others > ap-
pears.
Others
3 Press the 2 key.
4 Press the 3 or 4 key repeatedly until >Sleep Timer
> appears. The default setting is 030 min.
>Sleep timer
030 min.
5
Press the ENTER key. A blinking cursor ( _ ) appears.
>Sleep timer
030 min.
>
>
>
3-48