Basic System Operation; Turning An Area All On; Turning An Area Part On / Part 2 On - Bosch Solution 16i User Manual

Solution 16 User Guide
i
Pressing any key on the keypad sounds one
Key
short beep, indicating that the key press is
Press
accepted.
Tone
When you enter the premises through
a zone programmed for entry delay, the
keypad sounds a Hi/Low (repeat) tone to
Entry
remind you to turn off the area. If the area
Delay
is not turned off before the entry delay
Tone
expires, an alarm condition will sound and
a report (if programmed) will be sent to
your alarm company.
After you turn an area All On, the keypad
will sound 1 short beep every second.
Exit
During the last 10 seconds fast short beeps
Delay
will be heard. If you don't exit before the
Tone
delay time expires and an exit delay door is
faulted, an alarm occurs.
If you press an incorrect key, your keypad
Error
will sound a 2 second tone.
Tone
The keypad will sound a tone to indicate
Menu
when you enter or leave the MENU
Mode
Programming Mode.
The keypad sounds fast short beeps to alert
Chime
you when a zone programmed for chime is
Tone
faulted or unsealled.
Table 5: Keypad Tones and Their Meanings
Figure 3: CP510i ICON Keypad
8
B a s ic Sys te m O pe ratio n

Turning An Area All On

Use this function to turn the system All On. As soon as you
turn an area on, exit delay time will start. Exit time allows
you to exit the premises without sounding an alarm. Your
installer will program the length of exit delay time to suit
your premises.
1. Make sure that all zones are normal (not faulted).
The green indicator light will be on steady
2. Enter your PIN, then press the [ON] key.
If your PIN is valid and if all zones are normal, exit delay
time will start. You should leave now. If the control
panel detects a faulted zone, you should return it to
the normal condition, or manually bypass the zone.
During exit delay, you may stop the area from turning
All On by entering your PIN followed by the [OFF] key.
3. To turn the system (or area) off, enter your PIN, then
press [OFF].
The system is factory defaulted for one area. If your
i
installation has been configured for multiple areas it
Note
will be possible to turn on certain areas while leaving
others turned off.

Turning An Area Part On / Part 2 On

Use this function to turn an area Part On or Part 2 On. Part
On and Part 2 On modes can be used to turn on only part of
the area, leaving the rest of the area turned off.
Only your installer can program which zones are monitored
for Part On. However, a master user (default = User 1)
can program which zones are monitored when an area is
turned Part 2 On.
Once you have turned an area Part On or Part 2 On, exit
time will start. You should leave all zones that are active
before exit delay time expires. Leaving active zones after
exit delay expires causes an alarm event.
Use Part On or Part 2 On only when you want part of an
area turned on.
1. Make sure that all zones are normal (not faulted).
2. Enter your PIN, then press the [PART] key once.
If the area has zones programmed for Part 2, the keypad
will prompt the user to cursor between Part 1 and Part
2 options using the [] and [] keys before pressing the
[OK] key.
If your PIN is valid and all zones are normal, the area
will turn Part On and the exit delay time will start.
If your system has a faulted zone, you should return
it to the normal, or manually bypass the zone before
continuing.
During exit delay, you may stop the area from turning
Part On by entering your PIN followed by the [OFF] key.
Bosch Security Systems 6/09 BLCC500U FTR1.03