Basic System Operation; Turning An Area All On; Turning An Area Part On / Part 2 On; Turning The System Off - Bosch Solution 144 User Manual

Solution 144 User Guide
Error If you press an incorrect key, your keypad
Tone
will sound a 2 second tone.
The keypad will sound a Hi / Lo tone to
Menu indicate you have entered MENU Mode and
Mode
a Lo/Hi tone to indicate you have exited
MENU mode.
The keypad sounds fast short beeps to alert
Chime
you when a zone programmed for chime is
Tone
faulted or unsealled.
Table 4: Keypad Tones and Their Meanings
Figure 2: CP700B Graphic Keypad
B a si c Syste m O p e ration

Turning An Area All On

Use this function to turn an area All On. The control panel
is factory defaulted for one area. As soon as you turn an
area on, exit time will start. Exit time allows you to exit
the premises without sounding an alarm. Your security
company programs the length of exit delay time.
1. Make sure that all zones are normal (not faulted).
2. Enter your PIN, then press the [ON] key.
If your PIN is valid and if all zones are normal, exit delay
time will start. You should leave now. If your control
panel detects a faulted zone, you should return it to
normal, or bypass the zone.
During exit delay, you may stop the area from turning
on by entering your PIN followed by the [OFF] key.
3. To turn the system (or area) off, enter your PIN, then
press [OFF].
8

Turning An Area Part On / Part 2 On

Use this function to turn an area Part On or Part 2 On. The
control panel is factory default only for one area. Part On
and Part 2 On turns on only part of the area, leaving the
rest of the area turned off.
Only the security company can program which zones are
monitored for Part On. A master user can program which
zones are monitored when a user turns an area Part 2 On.
Once you have turned an area Part On or Part 2 On, exit
delay time starts to count down. You should leave all zones
that are active before exit delay time expires. Leaving
active zones after exit delay expires causes an alarm event.
Use Part On or Part 2 On only when you want part of an
area turned on.
1. Make sure that all zones are normal (not faulted).
2. Enter your PIN, then press the [PART] key.
If your PIN is valid and if all zones are normal, the
keypad will prompt you to select Part On or Part 2 On.
3. Using the arrow keys, highlight Part On or Part 2 On
then press [OK].
Exit delay time will start. You should leave now. If
your system has a faulted zone, you should return it to
normal, or bypass the faulted zone.
During exit delay, you may stop the system from
turning Part On by entering your PIN followed by the
[OFF] key.
4. When exit time has expired, the keypad will display
the Part On icon.
5. To turn the system off, enter your PIN, then press
[OFF].

Turning The System Off

When the system is on, you must enter through a designated
entry door to prevent an alarm. Opening a designated door
(e.g. front door) will start entry time. During entry time,
the keypad will emit a pulsing tone "beep" to remind you to
turn the system off. To turn off, enter your PIN followed by
the [OFF] key before the entry delay time expires.
If you enter through the wrong door or fail to turn the
system off before the entry delay time expires, you may
cause a false alarm. If this situation arrises, silence the
alarm by entering your PIN followed by the [OFF] key and
call your security company to let them know that it is not
an emergency situation.
1. Enter your PIN + [OFF] to turn the system (or area)
off. The keypad will no longer display the 'Lock' or
'Part' icons.
Bosch Security Systems 04/12 BLCC600U