Email Address; Email Options; Send Test Report - Bosch Solution 16i User Manual

Solution 16 User Guide
i
Comms > MyAlarm >

Email Address

This menu allows the master user to program the email
address that the system will send reports to.
1. Enter your Master PIN + [MENU].
2. Enter [5] + [5] + [8] + [OK].
The keypad will display the current email address.
3. Use the numeric, [0] to [9], [←] and [→] keys to enter
or hange the email address as required.
At any time you can use the [↑] and [↓] keys to scroll
through the complete list of available characters.
To clear all characters from the cursor position to the
right, press the [OFF] key.
4. When the email address is complete, press [OK] to
save and exit, or press [MENU] to exit without saving.
5. To stop email reporting simply remove the email
address or disable all of the email options.
When entering an email address the @ symbol is
i
represented on the keypad display as
Note
this character continually press the 1 key until the
symbol appears. For more information
see "Table 7: Text Character Set" on page 10.
Comms > MyAlarm >

Email Options

This menu allows the master user to program which types
of system events are sent via email.
Option
1
2
3
4
5
6
7
8
Table 13: Email Options
1. Enter your Master PIN + [MENU].
2. Enter [5] + [5] + [9] + [OK].
The keypad will display the current options which are
selected or enabled.
26
EMAiL
MENU 5-5-8
_
. To enter
E-OPtS
MENU 5-5-9
Description
Open/Close Reports
Zone Alarm
Zone Trouble
System
Access
Reserved
Reserved
Reserved
1 2 3 4
3. Use the [1] to [8] keys to turn on and off the features
as required. When the corresponding number on the
keypad is on then the option is selected.
4. When all email options are programmed, press [OK]
to save and exit, or press [MENU] to exit without
saving.
Comms > Periodic Test >

Send Test Report

This menu allows you to test the reporting functions of the
control panel by manually sending a 'Test' report to the
receiving party (i.e. security company monitoring station,
mobile telephone etc).
1. Enter your Master PIN + [MENU].
2. Enter [5] + [9] + [0] + [OK].
The test will begin and the keypad will display that
testing is in the progress. The test may take up to 3
minutes to complete.
If the test is successful, the keypad will prompt:
If the test is NOT successful, the keypad will prompt:
3. Press [OK] or [MENU] to exit.
-bit-
tst-dl
MENU 5-9-0
ph tst
pAss
fAil
Bosch Security Systems 6/09 BLCC500U FTR1.03