Direct Link Connect; Voice Setup; Set Domestic Phone Number; Call Forward On - Bosch Solution 16i User Manual

Solution 16 User Guide
i
Comms > Commands >

Direct Link Connect

This menu allows the master user to start a direct link
session without the need for the installer to press and hold
the default button.
1. Enter your Master PIN + [MENU].
2. Enter [5] + [0] + [5] + [OK].
Once the computer and the control panel establishes
a connection, the keypad will automatically return to
the normal state.
Comms > Commands >

Voice Setup

This menu allows the master user to record their own
customised greeting and zone description message that
will be played back to users that are programmed to receive
domestic telephone calls from the alarm system.
These messages should be clear enough so that the user
receiving the telephone call from the control panel can
then take the appropriate action.
This feature requires an optional voice module to be
fitted to the control panel by your installer. Additional
programming information is included with the voice
module.
Comms > Commands >

Set Domestic Phone Number

Domestic reporting allows the control panel to send
reports to 3 different personal telephone numbers (eg.
mobile telephone numbers). Each telephone number has
a maximum of 32 digits.
A telephone call needs to be acknowledged by the user
that answers the incoming call by pressing [#] on their
telephone. If the user fails to acknowledge the call, the
control panel will make another attempt to report until the
maximum number of call attempts are reached.
1. Enter your Master PIN + [MENU].
2. Enter [5] + [1] + [5].
If the control panel is not configured to report
via domestic format, the keypad will display the
following:
24
dircOn
MENU 5-0-5
cOnect
vOicE
MENU 5-0-6
Set-Ph
MENU 5-1-5
NO Opt
If the control panel has been configured to report via
domestic format, the keypad will display information
for telephone number 1.
3. Using the numeric keys, enter all of the digits of the
first telephone number that the control panel will
call.
You can change a single digit by scrolling the
cursor left [←] and right [→]. For special characters
(eg. Pause = P, A = *, H = # etc), use the [↑] and [↓] keys.
To clear or delete all numbers from the current cursor
position to the right, press the [OFF] key.
4. Press [OK] to program telephone number 2.
5. Using the numeric keys, enter all of the digits of the
second telephone number (if required).
6. Press [OK] to program telephone number 3.
7. Using the numeric keys, enter all the digits of the
third telephone number (if required).
8. Press [OK] to save and exit, or press [MENU] to cancel.
Domestic reporting must be programmed by your
i
installer or this location will not be available.
Note
Comms > Commands >

Call Forward On

When you leave your premises, you no longer need to
remember to manually activate the Call Forward On feature
on your telephone. This option allows you to program
the Call Forward On sequence that the control panel will
automatically use when you turn Area 1 'On' .
In Australia, a typical sequence for activating the Call-
Forward On are described in the following examples:
Ph1 ?
Ph2 ?
ph3 ?
cfOnPh
MENU 5-1-6
Bosch Security Systems 6/09 BLCC500U FTR1.03