Installing A Security Rope Clip - IBM xSeries 205 Type 8480 Hardware Maintenance Manual And Troubleshooting Manual

10. Replace the side cover. See "Replacing the side cover" on page 59.
11. Reconnect the external cables and power cords. Turn on the attached devices,

Installing a security rope clip

To help prevent theft, you can add a security rope clip and cable to your server.
Complete the following steps to install the rope clip:
1. Review the safety precautions listed in "Safety information" on page 117.
2. Turn off the server and all attached devices. Disconnect all external cables and
3. Use a screwdriver to remove the two metal knockouts.
4. Insert the rope clip through the rear panel; then attach and tighten the nuts.
5. Thread the cable through the rope clip and around an object that is not part of
position when the DIMM is firmly seated in the connector.
7. If there is a gap between the DIMM and the retaining clips, the DIMM has not
been correctly installed. Open the retaining clips, remove the DIMM, then
reinsert it.
8. If you have other options to install or remove, do so now.
9. Replace the frame-support bracket.
and turn on the server.
power cords; then, remove the side cover. See "Removing the side cover" on
page 40 for details.
or permanently secured to the building structure or foundation and from which
the cable cannot be removed. Fasten the cable ends together with a lock. After
you add the security cable, be certain it does not interfere with other cables
DIMM connector 1
DIMM connector 2
Chapter 4. Installing options
57