Using The Scsiselect Utility Program; Starting The Scsiselect Utility Program - IBM xSeries 205 Type 8480 Hardware Maintenance Manual And Troubleshooting Manual

device drivers for your server, and software that supports advanced networking
functions. After downloading, run the downloaded program launch.exe.
You Ethernet controller supports optional modes, such as teaming, priority packets,
load balancing, fault tolerance, and virtual LANs, which provide higher performance,
security, and throughput for your server. These modes apply to the integrated
Ethernet controller and to the controllers on supported Ethernet adapters.

Using the SCSISelect Utility program

SCSISelect is a menu-driven configuration utility program for servers that come with
a SCSI adapter installed. You can use SCSISelect to:
v View the default SCSI IDs
v Locate and correct configuration conflicts
v Perform a low-level format on a SCSI hard disk
The following sections provide instructions for starting the SCSISelect Utility
program and descriptions of the menu choices available.

Starting the SCSISelect Utility program

Complete the following steps to start the SCSISelect utility program:
1. Turn on the server.
2. When the <<< Press <CTRL><A> for SCSISelect Utility! >>> prompt appears,
3. When the Would you like to configure the host adapter or run the SCSI
4. Use the arrow keys to select a choice from the menu.
5. Follow the instructions on the screen to change the settings of the selected
press Ctrl+A.
Note: If an administrator password has been set, you are prompted to type the
password to start the SCSISelect Utility program.
disk utility? question appears, make your selection and press Enter.
items, and press Enter.
Chapter 2. Configuring your server
17