Power Button - IBM xSeries 205 Type 8480 Hardware Maintenance Manual And Troubleshooting Manual

5. Release the two tabs at the top edge of the bezel and pull the top of the bezel
6. Pull the bezel up to release the two tabs at the bottom edge of the bezel. Store

Power button

Before you begin:
v Read "Safety information" on page 117.
v Review the information in "System reliability considerations" on page 33.
To remove the power button, complete the following steps:
68
IBM xSeries 205 Type 8480: Hardware Maintenance Manual and Troubleshooting Guide
slightly away from the server.
the bezel in a safe place.
1. Turn off the server, if it is on.
2. Unplug the server.
3. Remove the side cover. See "Removing the side cover" on page 40.
4. Remove the front bezel. See "Removing the front bezel" on page 67.
5. If your server has hot-swap hard disk drives installed, remove them. See
"Hot-swap hard disk drive cage" on page 71.
Note: Be sure to remove the hot-swap drive bay filler panels so that they are
not damaged.
6. Rotate the drive cage outward until it locks in the vertical position, so that you
can reach through to the other side of the power-switch and LED panel cable.
7. To remove the power-switch and LED panel, press in on the tab on the left
side of the panel; then, squeeze the top and bottom of the right-side of the