Table of Contents
Advertisement
2. Connect the SCSI signal cable to the adapter and to one or more of the
3. Connect the SCSI-activity-indicator cable to the adapter and to the SCSI LED
4. Complete the installation of the optional SCSI adapter.
Installing a security rope clip
To help prevent hardware theft, you can add a security rope clip and cable to the
server. After you add the security cable, make sure that it does not interfere with
other cables that are connected to the server.
Before you begin, obtain the following items:
v A flat-blade screwdriver
v An adjustable wrench
v A 19 mm (0.75 in.) rope clip or wire rope (similar to National Manufacturing
v Threaded nuts that fit the rope clip
v A security cable
v A lock, such as a combination lock or padlock
Complete the following steps to install a rope clip:
1. Turn off the server and all attached devices. Disconnect all power cords and
2. Use a screwdriver to remove the two metal knockouts.
3. Insert the rope clip through the rear panel; then, attach and tighten the nuts.
4. Thread the cable through the rope clip and around an object that is not part of
signal-cable connectors to the rear of the SCSI devices.
connector on the system board (see "System-board internal connectors" on
page 70).
number 3230, stock number 176-735)
external cables; then, remove the side cover (see "Removing the side cover" on
page 26).
or permanently secured to the building structure or foundation, and from which
SCSI cable
RAID
adapter
SCSI connector
Chapter 4. Installing options
47
Advertisement
Table of Contents
