IBM xSeries 205 Type 8480 Hardware Maintenance Manual And Troubleshooting Manual page 54

10. If you have another adapter to install, repeat steps 1 through 10. If you have
11. If you have installed a full-length adapter, rotate the front adapter-retaining
12. Reinstall the rear adapter-retaining bracket; then, rotate the bracket to the
13. Replace the frame-support bracket.
14. Replace the side cover. See "Replacing the side cover" on page 59 for details.
15. Reconnect the external cables and power cords; then, turn on the attached
44
IBM xSeries 205 Type 8480: Hardware Maintenance Manual and Troubleshooting Guide
8. Remove the adapter from the static-protective package, carefully grasp the
adapter by the top edge or upper corners, and align it with the expansion slot
guides; then, press the adapter firmly into the expansion slot.
Note: It is best to move the adapter directly from the static-protective package
to the adapter slot. If this is not possible, set the adapter down on its
static-protective package on a hard surface. Avoid touching the
components and gold-edge connectors on the adapter.
Attention: Be certain that the adapter is correctly seated in the expansion slot
before you turn on the server. Incomplete installation of an adapter might
damage the system board or the adapter.
Expansion-slot
cover
Rear adapter-
retaining
bracket
9. Connect required cables to the adapter. Route cables so that they do not block
airflow from the fans.
another option to install, do so now.
bracket to the closed (locked) position.
closed (locked) position.
Note: The rear adapter-retaining bracket rests against the side cover. You
might find it easier to lay the server on its side to replace the side
cover.
devices and the server.
Adapter
Front adapter-
support bracket