IBM xSeries 205 Type 8480 Hardware Maintenance Manual And Troubleshooting Manual page 79

panel and carefully pull the panel away from the system.
8. Note where the power-switch and LED panel cable connects to the system
board; then, carefully disconnect the cable from the system board.
Notes:
a. You might need to remove the diskette and IDE cables to access the
power switch and LED panel cable connector.
b. Some cables might have two connectors for you to disconnect.
c. See the system service label for system board connector locations.
9. Disconnect the cable of the power button from the system board.
10. Place a screwdriver against the bottom release latch of the power button and
gently press upward and slide the latch through the aperture.
11. Gently pinch together the upper release latches and slide the latches through
the aperture and remove the power button.
Chapter 5. Field replaceable units
69