Diagnostic Error Codes - IBM xSeries 205 Type 8480 Hardware Maintenance Manual And Troubleshooting Manual

Note: See "System" on page 110 to determine which components should be replaced by a field service technician.
Diagnostics panel LED
TEMPERATURE LED on.
FAN LED on

Diagnostic error codes

Note: In the following error codes, if XXX is 000, 195, or 197, do not replace a
Note: See "System" on page 110 to determine which components should be replaced by a field service technician.
Error code/symptom
001-XXX-000 (Failed core tests)
001-XXX-001 (Failed core tests)
001-250-000 (Failed system board ECC)
001-250-001 (Failed system board ECC)
005-XXX-000 (Failed video test)
011-XXX-000 (Failed COM1 serial port test) v System board.
011-XXX-001 (Failed COM2 serial port test) v System board.
014-XXX-000 (Failed parallel port test)
FRU/action
1. Ambient temperature must be within normal operating specifications.
See "Features and specifications" on page 3.
2. Ensure fans are operating correctly.
3. Examine System Error Log.
a. System over recommended temperature
v Information LED panel
b. DASD over recommended temperature (DASD LED also on)
1) Overheating hard drive
2) DASD backplane
c. System over recommended temperature for CPU x (where x is 1 or 2)
(CPU LED is also on)
1) CPU x
2) System board
4. If the CPU LED on the diagnostics panel is also lit, one of the
microprocessors has caused the error.
1. Check individual fan LEDs.
2. Replace respective fan.
3. Fan cable.
4. System board.
5. Power cage assembly, if installed.
FRU. The description for these error codes are:
000 The test passed.
195 The Esc key was pressed to stop the test.
197 Warning; a hardware failure might not have occurred.
For all error codes, replace the FRU or take the action indicated.
FRU/action
v System board.
v System board.
v System board.
v System board.
v Extender card.
v System board.
Chapter 6. Symptom-to-FRU index
89