Travis Industries Xtreme 6020 Installation Manual page 38

38
The fireplace includes
two mounting plates
used to brace the
pieces of fiber board
along the side of the
fireplace. Position
the mounting plate so
the tabs on the side
of the fireplace insert
into the slots on the
mounting plates (see
picture directly to the
right). Then secure
the mounting plate to
the framing (picture
far right). Repeat this
process for the
opposite side.
Place the side fiber board in place and secure.
The top strips are installed over the tile stop.
These two pieces provide the 2" of non-
combustible material required above the tile stop
(used only for flush drywall – see "Facing Example
– Flush Drywall" on page 39).
© Travis Industries
Installation
(for qualified installers only)
4140717 100-01351