Download Print this page

Travis Industries 616 GSR Driftwood Installation Instructions Manual

Log set
Hide thumbs Also See for 616 GSR Driftwood:

Advertisement

Quick Links

 
 
 
Compatibility
616 GSR 
Packing List
7‐Piece Driftwood Log Set (not shown) 
 
Rear Burner Deflector, NG/LP Rear Air Deflector 
WARNINGS
Make sure the gas control valve is OFF and the heater is cool before conducting service. 
 
Failure to position the parts in accordance with these diagrams or failure to use only parts 
specifically approved with this appliance may result in property damage or personal injury. 
 
If using propane (LP), convert the appliance before installing the logs (see the owner's manual 
for details). 
 
Do not use crushed glass media with this log set. It causes excess sooting. Use included rock 
 
wool. 
 
Page 1 of 11
616 GSR Driftwood Log Set

Installation Instructions

Standoff Pack: Includes (4) Log Support Brackets, (6) 10‐24 Nuts 
 
17601714.docx — 8/23/12
 
Bag of Rock Wool, Bag of Embers 
(SKU 94500949)
 
 
© Travis Industries, Inc.

Advertisement

loading

Summary of Contents for Travis Industries 616 GSR Driftwood

  • Page 1: Installation Instructions

    616 GSR Driftwood Log Set Installation Instructions (SKU 94500949)       Compatibility 616 GSR  Packing List  7‐Piece Driftwood Log Set (not shown)      Standoff Pack: Includes (4) Log Support Brackets, (6) 10‐24 Nuts      Rear Burner Deflector, NG/LP Rear Air Deflector  Bag of Rock Wool, Bag of Embers  WARNINGS Make sure the gas control valve is OFF and the heater is cool before conducting service.    Failure to position the parts in accordance with these diagrams or failure to use only parts  specifically approved with this appliance may result in property damage or personal injury.    If using propane (LP), convert the appliance before installing the logs (see the owner’s manual  for details).    Do not use crushed glass media with this log set. It causes excess sooting. Use included rock    wool.      Page 1 of 11 17601714.docx —...
  • Page 2: Burner Installation

    616 GSR Driftwood Log Set Installation Instructions (SKU 94500949)       Burner Installation NOTE:  The insert should be in place, with the gas line and vent attached, and the firebacks installed  (see owner’s manual for further details) before proceeding.  1. Remove the rear burner as shown below.  NOTE: Remove the  attachment screw first.    2. Remove the 3 screws from the back of the rear burner using a ¼” nutdriver.            Page 2 of 11 17601714.docx — 8/23/12 © Travis Industries, Inc.
  • Page 3 616 GSR Driftwood Log Set Installation Instructions (SKU 94500949)       3. Attach the rear air deflector to the rear burner with the screws removed in the previous step.   NOTE: Verify the correct air deflector according to your fuel type  IMPORTANT: Make sure the air deflector holes are aligned, if they do not align flip the deflector  over.     NG Installation  This notch in the LP  deflector differentiates it  from the NG air deflector.      LP Installation  4. Replace the rear burner and secure with the attachment screw.  The two tabs on the rear  burner rest on top of the  front burner.           Page 3 of 11 17601714.docx — 4/30/13...
  • Page 4 616 GSR Driftwood Log Set Installation Instructions (SKU 94500949)       5. Install the rear burner deflector.  6. Attach the log supports with the 6 included nuts.      Page 4 of 11 17601714.docx — 8/23/12 © Travis Industries, Inc.
  • Page 5: Rock Wool Placement

    616 GSR Driftwood Log Set Installation Instructions (SKU 94500949)       Rock Wool Placement 7. Place the rock wool as follows:  a. Brush the rock wool using a stiff brush in a loose, gauze‐like layer.  TIP: Hold the rock wool in a tight wad with one hand while brushing with the other.        Note how the rock wool is approximately 1/8” thick over the burner ports.   TIP: Feel free to apply a generous amount of rock wool to gain a darker flame and a brighter  coal bed.            Page 5 of 11 17601714.docx — 8/23/12 © Travis Industries, Inc.
  • Page 6 616 GSR Driftwood Log Set Installation Instructions (SKU 94500949)       Log and Ember Chunks Placement The logs are fragile, especially after being exposed to heat.    IMPORTANT:  The burner must be correctly positioned before installing the logs.  Make sure the burner  is fully seated.    8. Place the rear log as shown below.           Move the log forward until it rests against the tabs on the burners.      Page 6 of 11 17601714.docx — 8/23/12 © Travis Industries, Inc.
  • Page 7 616 GSR Driftwood Log Set Installation Instructions (SKU 94500949)       9. Place the left middle log.  10. Place the right middle log.              Page 7 of 11 17601714.docx — 8/23/12 © Travis Industries, Inc.
  • Page 8 616 GSR Driftwood Log Set Installation Instructions (SKU 94500949)       11. Place the left cross log.        12. Place the pilot log.             Page 8 of 11 17601714.docx — 8/23/12 © Travis Industries, Inc.
  • Page 9 616 GSR Driftwood Log Set Installation Instructions (SKU 94500949)       13. Place the front right log.        14. Place the center cross log.               Page 9 of 11 17601714.docx — 8/23/12 © Travis Industries, Inc.
  • Page 10 616 GSR Driftwood Log Set Installation Instructions (SKU 94500949)           15. Place the ember chunks. Note that roughly half the bag of embers is left over.  Make sure that the ember chunks DO NOT cover any burner ports.    TIP:  The ember chunks should be placed so as to hide any sheet metal parts, rivets, and screws.        16. Re‐apply the rock wool over the ember chunks along the front burner and between the two  front logs for a natural look.   TIP: Natural gas (NG) can use more rock wool than propane (LP).  NOTE: Initial application of rock wool may cause “matting” over burner ports. Turning the unit  on and then off again will loosen the rock wool, resulting in a better flame.          Page 10 of 11 17601714.docx — 8/23/12 © Travis Industries, Inc.
  • Page 11 616 GSR Driftwood Log Set Installation Instructions (SKU 94500949)       17. Check the exhaust restrictor setting before finalizing the installation.  Restrictor Settings     Driftwood Logs Natural Gas Short Vent   (25’ or less) Natural Gas Tall Vent #3 (stock)   (25’ or more) Propane Short Vent  ...