Wiring The Exhaust Blower (Continued) - Travis Industries Xtreme 6020 Installation Manual

Wiring the Exhaust Blower (continued)


In addition to the exhaust blower line, a low-voltage wire harness is routed from the exhaust damper
to the fireplace (see page 6 for wire lengths and part numbers).
Route the exhaust damper wire harness through
the junction box plate (make sure to use the correct
end). Attach the molex connector from the
harness to the molex connector inside the exhaust
box assembly). Slide the strain relief over the wire
harness and press it into the junction box cover to
secure the wire.
Replace the junction box cover, making sure all
wiring is properly inserted.
Route the wire harness to the fireplace and attach
to the molex connector on the fireplace junction box
(see photo below) . Secure the wiring with the
included strain relief. Re-attach the junction box
cover (see photo below to right).
Caution: Label all wires prior to disconnection
when servicing controls. Wiring errors
can cause improper and dangerous
operation.
© Travis Industries
Installation
Molex Connector
Exhaust Damper Wire Harness
(for qualified installers only)
4140717
23
100-01351