Removing The Transfer Roller - Kyocera Mita KM-1500 Service Manual

2DC

1-6-6 Removing the transfer roller

CAUTION
Do not touch the transfer roller (sponge) surface. Oil and dust (particles of paper, etc.) on the transfer roller can
significantly deteriorate the print quality (white spots, etc.).
When refitting the bushes and springs, make sure to refit the black colored bush and spring on the left side. Also, observe
the correct direction to which the bush is fit in reference to the paper passing direction.
1. Remove the process unit (See page 1-6-2).
2. Remove the transfer roller from the both bushes.
Gear
Transfer roller
1-6-8
Bush
(Black colored)
Spring
(Black colored)
Figure 1-6-10 Removing the transfer roller
Paper passing direction
Long
Transfer roller
Bush
Spring
Short
Transfer roller
Bush