Table of Contents
Advertisement
2DC
(14) Adjusting the margins for scanning the original from the DP
Perform the following adjustment if margins are not correct.
U402
U403
(P. 1-6-43)
(P. 1-6-49)
Caution:
Before making the following adjustment, ensure that the above adjustments have been made in maintenance mode.
Procedure
Enter maintenance mode.
Enter "404" using the copy exposure
adjustment keys or zoom +/- keys.
Press the start key.
Select the item to be adjusted using
the copy exposure adjustment keys.
Exp. 1 (lit): DP left margin
Exp. 2 (lit): DP leading edge margin
Exp. 3 (lit): DP right margin
Exp. 1 (flashing): DP trailing edge margin
Press the program key and the
machine enters the test copy mode.
Place an original on the DP and press
the start key to make a test copy.
Are the margins correct?
Yes
Proceed to another mode?
Press the stop/clear key
to exit maintenance mode.
1-6-54
U404
Start
No
Yes
No
End
Ejection direction
(reference)
DP left margin
(3 ± 2.5 mm)
Press the start key.
The new setting is stored.
Change the setting.
• Increasing the value using the
zoom (+) key makes the margin
wider.
• Decreasing the value using the
zoom (-) key makes the margin
narrower.
Setting range (initial setting/change in value per step)
DP left margin: 0 – +10 (2.0/0.5 mm)
DP leading edge margin: 0 – +10 (3.0/0.5 mm)
DP right margin: 0 – +10 (2.0/0.5 mm)
DP trailing edge margin: 0 – +10 (2.0/0.5 mm)
DP leading edge margin
DP trailing edge margin
(3 ± 2.5 mm)
Figure 1-6-64
(3 ± 2.5 mm)
DP right margin
(3 ± 2.5 mm)
Advertisement
Table of Contents
