Table of Contents
Advertisement
2DC
1-6-9 Removing and splitting the fuser unit
WARNING
• The fuser unit is hot after the copier was running. Wait until it cools down.
CAUTION
• When refitting the fuser unit, make sure the fuser unit gear and the copier's drive gear are properly meshed with each
other. For this, rotate the main motor several turns before fixing screws.
1. Remove the rear cover (See page 1-6-3).
2. Remove the right and left cover (See page 1-6-4).
3. Remove the two connectors.
4. Remove two screws.
5. Remove the fuser unit.
Screws
1-6-18
Screws
Figure 1-6-20 Removing the fuser unit
Fuser unit
Connectors
Advertisement
Table of Contents
