Detaching And Refitting The Dp Conveying Roller And Dp Eject Roller - Kyocera Mita DP-100 Service Manual

(3) Detaching and refitting the DP conveying roller and DP eject roller

Follow the procedure below to clean or replace the DP conveying roller and DP eject roller.
Procedure
1. Remove the two connectors.
2. Remove the three screws and the terminal
and then remove the paper feed housing.
3. Remove the eject guide from the paper feed
housing.
Connectors
Figure 1-4-4
Eject guide
Figure 1-4-5
3HK
Screws
Paper feed housing
Terminal
Screws
Paper feed
housing
1-4-5