Adjusting The Margins For Scanning The Original From The Dp - Kyocera Mita DP-100 Service Manual

(5) Adjusting the margins for scanning the original from the DP

Perform the following adjustment if margins are not correct.
U402
(See the service manual
of the copier.)
Caution:
Before making the following adjustment, ensure that the above adjustments have been made in maintenance mode.
Procedure
Start
Enter maintenance mode.
Enter "404" using the copy exposure
adjustment keys or zoom +/- keys.
Press the start key.
Select the item to be adjusted using
the copy exposure adjustment keys.
Exp. 1 (lit): DP left margin
Exp. 2 (lit): DP leading edge margin
Exp. 3 (lit): DP right margin
Exp. 1 (flashing): DP trailing edge margin
Press the program key and the
machine enters the test copy mode.
Place an original on the DP and press
the start key to make a test copy.
Are the margins correct?
Yes
Proceed to another mode?
Press the stop/clear key
to exit maintenance mode.
U403
(See the service manual
of the copier.)
Ejection direction
No
Yes
No
End
U404
(reference)
DP left margin
(3 ± 2.5 mm)
Figure 1-4-11
Press the start key.
The new setting is stored.
Change the setting.
• Increasing the value using the
zoom (+) key makes the margin
wider.
• Decreasing the value using the
zoom (-) key makes the margin
narrower.
Setting range (initial setting/change in value per step)
DP left margin: 0 – +10 (2.0/0.5 mm)
DP leading edge margin: 0 – +10 (3.0/0.5 mm)
DP right margin: 0 – +10 (2.0/0.5 mm)
DP trailing edge margin: 0 – +10 (2.0/0.5 mm)
DP leading edge margin (3 ± 2.5 mm)
DP right margin
(3 ± 2.5 mm)
DP trailing edge margin
(3 ± 2.5 mm)
3HK
1-4-11