Priming The Shower - Mira Advance ATL J97A Installation Manual

9. Caution! Do not drill
into buried cables or
pipes.
12. Connect supply pipe.
Do not overtighten.
15. Important! Priming the Shower
Make sure electricity is isolated!
Push down and hold air bleed
button to prime appliance until
water flows from shower head
for a minimum of 10 seconds,
repeat 3 times. Failure to prime
will seriously affect shower
performance!
Carefully dry off water before
connecting / reinstating electricity.
Optional
Optional
Fixing Hole Required
Fixing Hole
Mira Advance ATL
Attention Installer
IMPORTANT! The following key details should be read in
conjunction with the Installation and User Guide.
Do not install the appliance where it
may become frozen.
Do not drill into buried cables or
pipes.
Avoid dust contamination of the
product by using this template to mark
and drill into the wall. Drill appliance
case separately.
Do not use alternative screws to
secure the cover.
Do not seal any part of the appliance.
Thoroughly fl ush the
pipework before connecting
to the appliance.
Use the correct supply cable
size. Refer to BS 7671.
For technical support and general enquires,
spare parts and after sales service contact us on:
Telephone : 0870 241 0888
Fax : 01242 282 595
email : mira_technical@mirashowers.com
Required
Fixing Hole
Optional
Optional
1083677-W7-A
10. Use template provided
t o m a r k a n d d r i l l
required fixing holes.
Do not drill through
the plastic case into
the wall. Plaster and
brick dust will damage
internal components.,
13. Turn on water supply
and check for leaks.
14
Leave minimum gap
to remove cover
Leave minimum gap to
install and maintain
© Kohler Mira Limited, May 2007
11. Drill holes through
p l a s t i c c a s e a s
required. Route signal
cable to shower drain
pump (if applicable).
Fix appliance to wall.
U s e a p p r o p r i a t e
screws and wall plugs
for fixing.
14. Connect hose and
showerhead, pointing
into bath or tray.