Basic Post Installation Checks - Mira Advance ATL J97A Installation Manual

Basic Post Installation Checks

1. Turn on electrical
supply.
4. Start shower to test for
water flow. If a shower
drain pump is fitted, it
should also start.
7. Appliance will purge water from
heater tank for a few seconds.
Important! DO NOT isolate power
until water has stopped.
Go to section: "Commissioning".
2. Power to appliance,
check Start/Stop for
blue light.
5 secs
5. If there is no water
after 5 seconds, make
sure that appliance
has been primed.
22
3. Temperature to full
cold.
6. Push Start/Stop to
turn off appliance.
P u l s i n g l i g h t a n d
"beep" indicates that
appliance is shutting
down.