Instantmatch By Whale® Digital Pump - Mira Advance ATL J97A Installation Manual

Instantmatch by Whale® Digital Pump
The Mira Advance ATL 'Extra' models can be connected to the Instantmatch by
Whale® Pump. This section describes how to identify and connect the shower to the
drain pump. For full installation instructions of the Instantmatch by Whale® Pump,
see separate guide.
1. Identify the drain pump model using the
corresponding number is shown on the drain pump transformer.
R
INSTANT
Input: 230Vac ~ 50Hz 800mA
Fuse T5A
Duty Cycle: 30min/60min
This transformer is only for use with:
SDP021T Shower Drainage Pump
F
Class II Indoor use
only
Jumper
location
DRIVER
2. Set the electronic jumper positions of the
according to the
Jumper Layout - See Instructions
MATCH
Post installation - To perform any
change to jumper settings, the power
supply must be switched off for
30 seconds prior to the change being made.
Type: 755.549
IP 45 30°C Max
Off
Delay
(Seconds)
10
30
TYPE
TYPE
number of the drain pump
TYPE
number in the table. The
Drain
Pump
Type
755.171
755.199
755.299
755.349
755.399
755.449
755.549
(Mira Advance Flex Extra Wireless J97P only.)
DRIVER
and
18
Shower
Driver Signal
LK1 Hardwired
LK1 Hardwired
LK2 Hardwired
LK2 Hardwired
LK2 Hardwired
LK2 Hardwired
Hardwired/
LK2
Wireless
SIGNAL
SIGNAL
in the shower