Drain Pump Registration (Flex Extra Wireless J97P model only)
The shower must register a wireless signal to the drain pump then establish a
reliable connection. If you encounter difficulty registering the shower to the drain
pump, make sure all electronic devices that could be causing signal interference
are temporarily switched off.
1. Set shower temperature to FULL COLD.
2. Shower is OFF.
NO water is flowing.
Power/Electric to shower is OFF.
Power/Electric to pump is ON.
3. Turn Power/Electric to shower ON.
4. Within 30 seconds push and hold PUMP
SWITCH until 'Beep' from shower and
pump switch power light changes
colour from RED/GREEN to GREEN to
indicate successful registration.
Drain Pump Test
5. Shower temperature to FULL COLD.
20
OFF
RED /
ON
GREEN
Transformer
ON
GREEN