Slp Settings; To Specify Slp Settings - Konica Minolta BIZHUB 600 User Manual

Specifying Settings From the Control Panel
3.28

SLP Settings

The use of SLP can be enabled or disabled. If set to "Enable", devices can
be searched using TWAIN. If set to "Disable", device cannot be searched.

To specify SLP settings

1
In the Administrator Setting screen, touch [5 Network Setting]. (Refer to
page 3-8 for more details.)
2
In the Network Setting screen, touch [0 Detail Setting].
3
In the Detail Setting screen, touch [6 SLP Setting].
The SLP Setting screen appears.
4
Touch [Enable] or [Disable].
5
Touch [OK].
The use of SLP is enabled or disabled.
Note
To cancel changes to the setting, touch [Cancel].
To quit specifying the Utility mode setting, touch [Exit] in the sub display
area. Otherwise, cancel the Utility mode by touching [Close] in each
screen until the screen for the Copy, Fax, Scan or Box mode appears.
bizhub 750/600
3
3-115