Crankcase Assembly - Husqvarna TE 250 - 310 2011 I.E. Workshop Manual

ENGINE REASSEMBLY

Crankcase assembly

Clean the crankcase half mating faces and place crankcase half on tool no.
8A00 90662.
- Heat up to around 125 °C and drive the ball bearings into each crankcase
half using a suitable driver tool.
- Fit the retaining plates (1) and (2) to the crankcase bearings.
(5 Nm, 0.5 Kgm, 3.6 ft/lb + Loctite 272) for crankshaft bearing retaining plate
(1).
(11 Nm, 1.1 Kgm, 7.9 ft/lb + Loctite 272) for right-hand bearing retaining plate
(2).
H.22 Ed. 07-2010