Husqvarna TE 250 - 310 2011 I.E. Workshop Manual page 359

Ed. 07-2010
CHASSIS AND WHEELS
Reassembling the front wheel
Fit the L.H. spacer on the wheel hub.
Fit the wheel between the fork legs so as to set the brake disc into the calliper.
Fit the wheel axle (2) from the R.H. side, after greasing it and push it fully
home against the L.H. fork leg; during this operation, the wheel should be
turned.
Tighten the screw (3) on the fork L.H. side but DO NOT lock it. Now, pump for a
while, pushing the handlebar downwards until you are sure that the fork legs are
perfectly aligned. Lock: the screws (1) on the R.H. leg (10.4 Nm, 1.05 Kgm, 7.7
ft/lb), the screw (3) on the L.H. side (51.45 Nm, 5.25 Kgm, 38 ft/lb), the screws
(1) on the L.H. leg ( 10.4 Nm, 1.05 Kgm, 7.7 ft-lb).
After reassembly, pull the brake control lever until the pads are
against the brake disc.
Y.7