Husqvarna TE 250 - 310 2011 I.E. Workshop Manual page 148

ENGINE OVERHAUL
1- Pressure plate, 2- Clutch actuator plate, 3- Pushrod, 4- Piston assembly: Check these parts for signs of wear or failure. If
any are found, replace the part.
5- Clutch hub: Check the steel plate slots for signs of wear or failure. If any are found, replace the part.
6- Clutch housing: Check the friction plate slots for signs of wear or failure.
Check the needle roller bearing seats for signs of wear. If any are found, replace the part.
7- Primary drive gear pair: Check gear teeth for signs of wear or failure. If any are found, replace the part.
G.18 Ed. 07-2010