Husqvarna TE 250 - 310 2011 I.E. Workshop Manual page 241

Ed. 07-2010
REAR SUSPENSION
Push on the reservoir valve to discharge the gas.
Aim valve away from you to prevent any debris from getting into your
eyes.
Reservoir cap and valve removal
Locate a suitable tool to reservoir cap and push down on cap until gaining ac-
cess to the retaining ring.
Push down with your hand and use great care.
Prise out the retaining ring using two small screwdrivers. Take care not to dam-
age the inner surface.
To remove the retaining ring, first prise one end of the ring out of its groove. Then
slide out the other end, slip the tip of a screwdriver between ring and reservoir
and prise off with the other screwdriver. Take out the retaining ring. Check the
grooves in reservoir body for burrs. If any burrs are detected, they must be re-
moved and the grooves must be reconditioned.
Screw a pipe with inner thread onto the cap and extract the cap using pliers.
J.7