Kodak RP 50 2J0686 Operator's Manual page 95

Error
Error Message
Code
15 timers busy
16 timer spurious interrupt
code
17 command not
implemented
18 unexpected OCP reply
20 pec service mode
21 opc service mode
22 end of roll, remove
paper at sht xprt
23 in error state
24 middle of load
25 wait proc
26 xport back door open
27 xport front door open
28 unit does not fit
29 sheet fogged in sheet
xport
30 unexpected knife
neither limit
31 door opened briefly
64 bad msg checksum
October 2002
Possible Cause
A low level motor move command
was issued while the timer motor
was in use.
A spurious (false) timer interrupt
has occurred.
The function requested is not
supported in this software release.
The 300 board sent an unexpected
message to the 200 board.
The service switch for the 200
board is on, enabling on-board
LEDs that can cause fogging.
The service switch for the 300
board is on, enabling on-board
LEDs that can cause fogging.
The paper cassette is empty and
tail of the paper has been fed into
the sheet transport area.
A previous error has not been
cleared.
Attempting to perform a function
while paper is being loaded.
Attempting to perform a function
while the printer detects a problem
with the processor.
The back sheet transport door was
left open.
The front sheet transport door was
left open.
The sum of all the unit setups since
the last print start exceeds 33
inches.
A door was opened while sending a
sheet from the printer to the
processor.
Knife not detected at either end.
The door was opened and closed.
A problem with a prom has
occurred.
Diagnostics and Troubleshooting
Possible Solution
Wait for the motor move to complete
or stop the motor and reissue the
command.
No solution required.
No solution required.
Call for service.
Call for service.
Call for service.
Pull the paper tail out of the sheet
transport area near the knife.
Reinitialize the printer.
Wait until paper loading is complete
and perform the function again.
Turn on the processor. Wait for the
processor to warm up and then
reinitialize the printer.
Close the back sheet transport door.
Close the front sheet transport door.
Begin printing.
Reprint.
Call for service.
Reinitialize the printer.
Call for service.
5-5