Setting The Page Starts Value - Kodak RP 50 2J0686 Operator's Manual

System Operating Procedures

Setting the Page Starts Value

The value for "page starts" indicates the number of pixels between the back wall
of the printer and the edge of the image. For example, when the printer begins to
print, it moves the print head to the back wall of the printer and then advances it
toward the front of the printer by the number of pixels specified in the "page starts"
parameter (value).
The "page starts" value is set so that the image edge closest to the back of the
printer will print off the paper and will then be borderless on the back edge of the
print.
NOTE: If the image size is wider than the paper, the front edge of the image will
also be borderless.
1. Select "Setup" from the main menu on the OCP.
2. Select "Printer".
3. Select "Page Starts".
4. Select the page start you wish to modify.
5. Use the Up and Down Arrows to select a new page start value.
6. Press Select to select the new value.
7. Select "Exit" to return to the previous menu on the OCP.
October 2002 3-19