Editing Information On The Density Source Tab - Kodak RP 50 2J0686 Operator's Manual

Additional Calibration Information
Density Source
Attribute
Density Source
Density Source Port
Density Source File
C-24

Editing Information on the Density Source Tab

The Density Source tab specifies how the calibration application is to receive
density data. The values displayed in the example are the default settings.
Indicates the source (densitometer or file) of the density data.
Indicates the name of the RS-232 port that the densitometer is
connected to. This port is the source of the density data. The name of the
port is specific to the computer system platform.
Indicates the filename for the source of density data. This is only used if
the Density Source is a file. If you designate a file as the density source,
this is the file name you use for "Creating a Density File for Use with
Calibration" on page C-32.
To edit the configuration information on the Density Source tab:
1. Use the drop-down lists to change the Density Source information as needed.
2. If you have completed all editing of configuration information (including
information on the other tabbed screens), click OK to save the changes and
close the Edit Configuration screen.
NOTE:Click Cancel to cancel all changes made to the Edit Configuration screen
and close the Edit Configuration screen.
3. To continue making changes to the Edit Configuration, click on another tab
and make changes as needed.
Description
October 2002