Kodak RP 50 2J0686 Operator's Manual page 96

Diagnostics and Troubleshooting
Error
Error Message
Code
65 proc stopped taking
sheet
66 paper jam in shoe
67 rotor not up to speed
68 xltr hard limit detected
69 unexpected xlator front
limit
70 xlator front limit not
detected
71 unexpected xlator back
limit
72 xlator back limit not
detected
74 paper present not
detected
75 unexpected 11 inch
paper
76 11 inch paper not
detected
79 unexpected paper at
shoe entr
77 unexpected 20 inch
paper
5-6
Possible Cause
The paper did not disappear from
the sheet transport area within the
expected amount of time. An error
may have occurred in the
processor.
Jam detect sensor detected
jammed paper at the shoe
entrance.
An obstruction in the shoe area
prevented the rotor from achieving
the correct speed in the expected
amount of time.
Either the front or back hard limit
switch was actuated.
The translator front limit switch was
detected unexpectedly.
The translator front limit switch was
not detected after moving translator
to the front of the printer.
The translator back limit switch was
detected unexpectedly.
The translator back limit switch was
not detected after moving translator
to the back of the printer.
Paper was detected at the
11 and 20 inch paper sensors but
not at the 10 inch paper sensors.
Paper was detected at the
11 inch paper sensor but not at the
10 or 20 inch paper sensors.
Paper was detected at the
10 inch paper, 20 inch paper, shoe
entrance and the knife sensors but
not at the 11 inch paper sensor.
Paper was detected at the shoe
entrance sensor but not at the
paper width sensor.
Paper was detected at the
20 inch paper sensor but not at the
10 inch or 11 inch paper sensors.
Possible Solution
• Clear a paper jam from sheet
transport (chad) area. See
"Clearing Printer Paper Jams" on
page 5-11.
• Wait a few minutes for the error
condition to be corrected.
• Reinitialize the printer and call for
service.
Remove jammed paper and reload
the paper.
Wait for at least 1 minute, then clear
the obstruction in the shoe and
confirm that all doors are closed.
• Move the translator off the front or
back hard limit switch. Use the
translator knob.
• Call for service.
Confirm that all doors are closed and
reinitialize the printer.
Confirm that all doors are closed and
reinitialize the printer.
Confirm that all doors are closed and
reinitialize the printer.
Confirm that all doors are closed and
reinitialize the printer.
Check that the paper is loaded and
threaded properly.
Check that the paper is loaded and
threaded properly.
Check that the paper is loaded and
threaded properly.
Remove any paper from the shoe.
Check that the paper is loaded and
threaded properly.
October 2002