Kodak RP 50 2J0686 Operator's Manual page 114

Diagnostics and Troubleshooting
Error Error Code /Status
Code Message
910 Configuration file
field:_filename_is invalid.
Calibration will be cancelled.
911 Error_errcode_occurred.
Processing stopped.
919 Error occurred preparing to
handle exit from Kodak
Calibration. Will not perform
cleanup at exit.
921 Unable to return the printer
to its original state. Fix
printer problem and re-
calibrate.
922 There is already a printer
open. Please close the open
printer first.
923 An error occurred during the
loading of a printer. Please
check to make sure the file
chosen was of the correct
type and/or format.
924 No printer loaded.
941 The height and width values
do not agree with the size of
the target file.
942 Unable to configure
densitometer. Densitometer
configuration file may be
corrupt or lost.
1003 Unable to load default
configuration file:_filename_.
1004 Unable to set values
in new configuration file.
1005 Unable to save configuration
file:_filename_.
1006 Configuration file field:_field_
is invalid.
1007 Unable to remove
directory:_directory_.
5-24
Possible Cause/Subsystem
The user manually edited a field
in a configuration file and entered
an incorrect value.
An internal error occurred with the
software.
An internal error occurred with the
software.
The application was trying to
cancel but received an error when
sending the original LUT back to
the printer.
User tried to open a printer when
the printer was already open.
An error occurred during the
loading of a printer.
The operator has not yet opened
a printer.
The specified size does not match
the file size.
The file CalDevDensGen2.cfg is
corrupt or lost.
The default configuration file was
deleted or renamed or moved.
An internal error occurred with the
software.
The system is trying to save a file
but there is not enough disk
space.
The user manually edited a field
in a configuration file and entered
an incorrect value.
User does not have update
authority on the directory.
Possible Solution
• Manually enter the correct
value.
• Reinstall the application.
• If problem continues, call for
service.
Restart the application.
Restart the application.
Printer is in an unknown state.
Correct any printer problems and
restart the application.
Close the open printer.
Check that the file chosen was of
the correct format or type.
Open a printer.
Enter the correct file size.
Restart the application. If problem
continues, call for service.
Restore the file manually or
reinstall the software.
Restart the application.
Remove any unnecessary files to
increase free disk space.
• Manually enter the correct
value.
• Reinstall the application.
Verify that the user has authority
on the directory.
October 2002