Selecting A Mode For Configuration - Kodak digital science 7500 Installation Instructions Manual

Selecting a mode for
configuration
3-4
Perform the following steps to select a mode for configuration.
NOTE: Not all items available for definition need to be defined. If you
wish to allow an item to default or have performed a Mode to
Mode copy after fully defining the Copy From Mode, there is
no need to define each item.
Mode Configuration
Define Mode 1
Define Mode 2
Define Mode 3
Define Mode 4
Define Mode 5
Define Mode 6
Define Mode 7
Define Mode 8
Define Mode 9
Define Mode 10
Define Mode 11
Define Mode 12
Define Mode 13
Define Mode 14
Define Mode 15
Define Mode 16
Define Mode 17
Define Mode 18
Mode to Mode Copy
End Session
Previous Menu
Select Define Mode x , where x is the number of the mode you wish
to configure.
The Mode Configuration window will appear:
Mode Number: 01 Mode Name: MODE01
Mode Configuration
Single
Index Format
6006
IA Field Width
3111
Level Rules
Supprs
IA Display Format
FthenR
Adjoining IA
None
Batching
Off
Length Monitor
Off
Skew Monitor
NA NA
Footswitch
Save & End Session
Save & Prev Menu
Mode configuration items may be selected from this window. A
detailed description of each item is provided in this section.
Item #: 0.0
Patch Reader Off
COIN2 Port Select n/a
OCR n/a
Bar Code Reader Off
Printr Controller Supprs
Front Printer Off
Rear Printer Off
Mode Name MODE0
Overrides No Sav
Don't Save & End Session
Don't Save & Prev Menu
A-61074 April 1997