Patch Reader; On/Off - Kodak digital science 7500 Installation Instructions Manual

Patch reader

A-61074 April 1997
NOTE: The patch reader is an accessory which must be installed
and enabled by your Field Engineer.
Patch reader defines the options required when using the patch
reader accessory.
Select Patch Reader from the Mode Configuration window.
Mode Number: 01 Mode Name: MODE01
Mode Configuration
Single
Index Format
6006
IA Field Width
3111
Level Rules
Supprs
IA Display Format
FthenR
Adjoining IA
None
Batching
Off Length Monitor
Off
Skew Monitor
NA NA
Footswitch
Save & End Session
Save & Prev Menu
The following pages provide instructions on how to define the patch
reader options. When the patch reader definitions are complete, you
will automatically be returned to this window.
To close the Patch Reader menu:
Select Previous Menu . Proceed to make any additional mode
configuration definitions.
NOTE: If the patch reader was not defined as Present during
Accessory Configuration, the following message will appear:
The accessory that you requested is not enabled in
Accessory Configuration.
Press Enter to clear the message.
Exit from Mode Configuration; refer to the section entitled Exiting
Mode Configuration .
Select Save & Previous Menu.
Contact your Field Engineer to install and enable this accessory.
Item #: 10.0
Patch Reader Off
COIN2 Port Select n/a
OCR n/a
Bar Code Reader Off
Printr Controller Supprs
Front Printer Off
Rear Printer Off
Mode Name MODE0
Overrides No Sav
Don't Save & End Session
Don't Save & Prev Menu
Patch Reader

On/Off

Transfer Patch Definition
Confirmation Tone
Level Transfer on T-Patch
Previous Menu
3-37